How to fix the flash

Useful article this time is set way in the repair of damaged flash either from her or from the device software. Flash problem was manifold, when talking with the technicians then we will know where the damage. but when talking with people who despise looking for tutorials on the internet like me, then the damage will not be so obvious, that right is not it?

therefore I suggest you to try the following methods before deciding to buy a new flash (calculated saving money)
* HOW TO FIRST The first way is the easiest way to use CMD. usually potent if the damage is only corrupt or badsector errors in flash software.
 1. Open CMD. (click Start - Run - type cmd - press ENTER)
 2. Plug the flash that is broken,
 3. type FORMAT H: / FS: FAT then ENTER.
H is the location of your flash, if the location of the flash in the explorer is G then FORMAT G: / FS: FAT then ENTER.

* HOW TO BOTH still using the CMD. But there is little difference, which is merely check
 1. Open CMD. (the same way as above)
 2. Plug the flash that is broken,
 3. type CHKDSK / f H: then ENTER
 4. Press Enter until the check is completed.

* HOW TO THIRD-use features of Windows Check Disk
1. Plug the flash and then open Windows Explorer
2. Right-click the stick - Properties - Tools - Check Now
3. Check that there is a second option. "Automatically fix file system errors" and "Recovery of bad sectors"
4. Wait until the process is complete.

* HOW TO FOURTH using the Computer Management
 1. Plug the flash damaged
2. enter RUN then type compmgmt.msc - ENTER
3. Click on Storage and select Disk Management
4. If no flash is detected, right-click - Create Partition. then right click again - FORMAT

 * HOW TO FIFTH your flash seems fairly yuk damage directly to more extreme ways
1. Plug the flash
2. Download the software called HDDGURU Low Level Format
3. Install the program, then "Run As Administrator" for Windows Vista / 7/8.
4. Select the type of USB and then Continue.
5. After low-level formatting is complete, you can reformat the flash with the way the format as usual.

* HOW TO SIXTH using the HP Drive Key Boot Utility Quick Format
1. Plug the flash
2. Download the software called HP Drive Key Boot Utility
3. Install the software (Windows XP only)
4. Run the program - Select the type of FAT / FAT32.
5. Select QUICK FORMAT - Create New or Replace Existing Configuration.

*HOW TO SEVENTH by searching software from vendors using idVendor and idProduct
1. Download a software called USB Device Viewer
2. Plug the flash drive
3. Run the program (Run As Administrator for Windows 7 / Vista / 8)
4. Will be detected all connected devices, such as the mouse, modem etc. To make sure, select USB mass Storage. Unplug and re-enter.

5. Record idVendor and idProduct. in this case, I noted (idVendor: 0951) and (idProduct: 1624) 6. Go to this address >>> http://flashboot.ru/iflash/ 

7. Put idVendor to idProduct to VID and PID - click ENTER

8. It would appear some results, please Browsing Tools that I put a red mark as shown below

9. google search results directly leads to the official website KINGSTON

10. Open the link and I was immediately taken on a software utility that is specific to the IC flash repair damaged / corrupt / the error.

11. Download the software and use as needed.

* until here good luck, any kind of damage caused by the fault is not the responsibility of the author. Dare to try is the initial capital to solve a problem